Mounting
Column/Portable Base
Column
3 (Front, 2 Sides)
Tank Locking Bar (See Pre-Pack Below)
(Propane Model)
1 Pre-Pack
12 Ft. Hose with Quick Disconnect
(Natural Gas Model)
1
Base
1
Locking Casters
4
Carton contains the following column and base components for
assembly:
Please check to be sure that all parts are included before
proceeding. Contact your dealer or the factory if any parts are missing.
8
Pre-Packaged Part and Fasteners
Tank Locking Bar
- Nylon Spacer, 2 3/4” Hex Bolt, Flat Washers (4) and Kep
Nuts (2)
HARDWARE
QUAN.
USE
1/4-20 x 1/2” Hex Head Bolt
12
Column to Base
Flat Washer
24
Column to Base
KEP Nut
12
Column to Base
1/4-20 x 1/2” Hex Head Bolt
8
Heat Shield to Column
Flat Washer
16
Heat Shield to Column
KEP Nut
8
Heat Shield to Column
Step 1:
Mounting Column to Base
.
Grill
Flat Washers
Hex Headl
Kep Nut
A. Attach the front (center) section of the column to the base using
2, 1/4-20 x 1/2” hex head bolts, 4 flat washers and 2 Kep nuts.
(Fig. A)
B. Attach the two (2) sides of the column to the base using 4, 1/4-20
x 1/2” hex head bolts, 8 flat washers and 4 Kep nuts. (
Fig. B)
NOTE: Washers should be placed
after the hex head and before the
Kep nuts. Follow through-out
assembly.
C. Attach sides of column sections using 6 1/4-20 x 1/2” hex
head bolts, 12 flat washers and 6 Kep nuts.
D. Insert heat shield into top of column using 8 1/4-20
X 1/2” hex head bolts, 16 flat washers and 8 Kep
nuts.
(Fig. D)
E. Lay base on its side and place caster stem into
stem opening of base, press and snap into place.
(Fig. E)
F. Attach the tank lock bar across the back of the col
umn. Use the 3/4” Hex bolt, 4 Flat Washers, Nylon
Spacer and the Kep nut on each side to fasten the
bar in place. (
Fig. E-1)
Fig. A
Fig. B
Heat Shield
Fig. D
Nylon Spacer
Hex Bolt
Kep Nut
Fig. E-1
Flat Washer
Grill
Fig. E
Nylon Spacer
Mounting
Tank Locking Bar
