MGS MK-2-EXT, Assembly Instructions Manual

Page: 8 / 12

Attach Bottom Clamping Collar to Cross Bars
Make sure top and bottom collar clamps are aligned.
Attach support bar to bottom collar tab using
(D) 1/4 x 3/4 short screw
as follows:
Note: Facing the assembly, the screw head should be on the left side
this time. This is to mitigate abrasion during transport of the tripod.
Left to right:
Screw head, Nylon spacer, support bar, nylon spacer, collar tab, nylon
spacer, lock nut
Place
(F) nylon spacer on (D) 1/4 x 3/4 short screw.
Insert screw through (#3) cross bar .
Add the flat side of the (G) Shaped Cross Bar Spacer .
Insert screw assembly through leg.
Add
(F) nylon spacer on outside of leg then (E) lock nut onto screw.
Tighten the nut; but allow the cross bar to swing freely.
Assembly Sequence: Assembled
Attach Neoprene Feet
Use a clear silicone sealer
(like Dap Silicone, Dow Silicone, etc…)
to attach the (#7)
neoprene feet onto the bottoms of the feet assembled on the legs. Apply silicone to one
side of the neoprene pads. Cover the entire surface with a thin layer. Place the pad on
the metal foot with the large hole matching orientation. Apply even pressure to the pads
to ensure there are no voids between the pad and foot left unfilled. After doing the even
pressure method, press on the pad and slide the pad on the foot ever-so-slightly in a
figure-8 pattern. This will ensure even spread of the adhesive.