Attach Cross Bars to Legs
Stand top collar and leg assembly up
–
spread each leg, out
from the center, about one foot apart.
Locate hole in
(#5) upper leg
25.125 inches from the bottom
of leg
(it’s the only hole toward the middle of the leg, but the
orientation of this hole is crucial to the operation of the
tripod.) Be sure that the middle hole is closer to the bottom
of the leg than the top. This is where the support bar is
attached.
Attach
(#3) cross bar
to the leg assembly using 2-1/4
”
long screw as follows:
Note:
Facing the assembly, the screw head should be on the right of leg (same side as
shaped spacer). If screw is tight, going through the cross bar, simply use the provided
hex L-Key to thread the screw through it. The powder coating is quite thick and
tolerance levels are very close.
Screw head - Nylon Spacer
–
Support Bar - Shaped Spacer - Leg
–
Nylon spacer-
Lock nut
Place
(F) nylon spacer
on
(C) 1/4 x 2-1/4
long screw.
Insert screw through
(#3) cross bar
.
Add the flat side of the
(G) Shaped Cross Bar Spacer
.
Insert screw assembly through leg.
Add
(F) nylon spacer
on outside of leg then
(E) lock nut
onto screw.
Tighten the nut; but allow the cross bar to swing freely.
Assembly Sequence: Assembled
Summary of Contents for MK-2-EXT
Page 1: ...TRIPOD MAST MOUNT...
Page 3: ......
