150 Dodd Street SE
Marietta, GA. 30060
Phone:
770-973-6251
Email:
Fax:
678-401-3854
Website:
Installation Guide
Type N female, Crimp-On, Cable End Connector for .590 Coax P/N 7306-N-600
We will begin by installing the Type N female connector on a piece of LMR-600. This
process is the same for all the other types of cable with an outer jacket OD of 0.590.
These connectors fit on a wide range of coax types including, but not limited to: RG-
217/U, LMR-600, and other 0.59 inch OD coax.
Identify all connector parts (3 Parts):
Each connector consists of one body assembly (jack), one rear ferrule (crimp sleeve),
and one center pin (jack contact).
Coax Stripping:
First cut your cable to the desired length and then strip the black jacket back
approximately 0.83 inches. When the jacket is stripped cut the braid/foil back 0.23
inches from the fresh cut end. Finally, cut back the dielectric 0.16 inches from the fresh
end down to the center conductor. The braid needs to be cut back further than the
dielectric to insure that none of the braid or foil is touching the center conductor which
could cause a short.
