MGI JETVARNISH 3DS, User Manual

Page: 61 / 176

JETVARNISH 3DS 8. How to use the machine
User Manual - 61 -
8.1.6 Air flow adjustment
[16] Compressor location
[17] Compressor
[18] Vacuum adjustment handle
[19] Blowing adjustment handle
The power of the air flow can be adjusted in order to separate correctly the different printing substrate
according to their thickness.
The vacuum [18] is always set at 100%.
The blowing [19] can be adjusted depending of the thickness of the substrate. The default value is 30%.
Tips: Between the maximum (to the end) and the minimum (handle release). you can make 3 turns. To
be at 30% turn until the handle is release then make 1 turn in “+” direction.
8.1.7 Side cleats stack adjustment
[20] Handles
To adjust the width of side cleats stack. first release the two handles [20] to be able to slide the side
cleats stack on the ruler. Move aside the side cleats stack at maximum distance. Put the printing
substrate to the middle of the feeder plate and put side cleats stack in contact with printing substrate
on one side and leave a little slack on the other side. Retighten the two handles [20] to fix the position
of side cleats.
[16]
[17] [18] [19]
[20]