4
“
” and “
“
buttons
: press these buttons to adjust the shock & vibrate intensities from levels 1 to 10.
“
”
button
: it is the power switch. Hold this button for 4 seconds to switch on the power then the LCD will display
the default “A01”. You may change this by pressing the relative buttons. To switch off the power hold this button for
4 seconds.
“
”
button
: no-stimulation just a warning buzz
“
”
button
: a continuous stimulation whilst held down. Will cut out after 8 seconds for safety.
“
”
button
: momentary stimulation
“
" button:
vibrate button, press one time , vibrate 1 time. Press and hold on gives up to 8 seconds vibration
before cutting out.
“A,B,C ”
buttons
: Dog selection buttons. The default is
“A”
. Your transmitter is capable of training up to three dogs
with optional extra receiver collars. When you select A dog the LCD displays dog ID “A XX”. If you want to train B dog,
press
“B”
button and the LCD will display “BXX”. If you want to train C dog then press the
“C”
button and the LCD will
display “C XX”. “XX” is for showing the shock level or vibrate level.
High-Light operation
:
After matching the collar with the transmitter, when you press button A and keep your finger
on the button the collar will flash a white light. Remove finger and press button A again and the light will turn off.
Likewise, collar B will flash a red light and collar C will flash a green light. These lights are visible for 200 to 300
metres in the dark and can be of great assistance in finding out which dog is where.
The memory functions in the transmitter will save the shock & vibrate levels which you set for different dogs.
There are 10 levels of continuous stimulation, 10 levels of momentary stimulation. 10 levels of vibrate, One tone
NOTE: The red LED light will flash when the battery is low. Please then recharge the battery at once.
