MG TR-EVO, Instructions For Use Manual, Page: 3 / 24

Introduction
The TR-EVO temperature controller is a valid tool to adjust temperature in heating elements,
without using external sensors.
By taking advantage of the voltage-current characteristic, the TR-EVO manages to maintain the
temperature set even in conditions of high heath loss, thereby obtaining considerable benefits
compared to traditional methods used.
To reach the temperature set in the least time possible (100 ÷ 350 ms) and keep it constant means
obtaining an increase in operating speed, but also an extended operating life of the heating part,
and enables less waiting times due to thermal inertia or dispersions of the various metal parts
supporting the heating element.
The TR-EVO was designed to be controlled or control, from the simplest electro-mechanical
packaging machines to the most complex packaging lines with PLC or PC.
All the operating parameters can be entered using the display or the integrated serial port RS485.
Extremely easy to use, highly functional and compact, this system is the strength of heat sealing
processes, including with hot air, temperature control, hot cutting, etc...
Warnings
ATTENTION: for correct use of your temperature controller, it is essential to
comply with the instructions in this manual. You are advised to read each part of it
carefully before start-up, to prevent possible damage due to improper actions.
Avoid installing the equipment in the immediate vicinity of high power units, relays,
motors, etc.
The equipment is NOT equipped with an ON/OFF switch, therefore it switches on as
soon as it is connected to the power supply.
The power supply should have adequate protection against any short circuits or
anomalies on the equipment.
Install connections using cable types with adequate sections for the voltage and
current limits specified in the manual.
Check the system has a good ground connection.
Do not use the equipment in environments with a dangerous atmosphere
(inflammable or explosive).
TR-EVO operation implies use of specifics alloys for the heating elements. Use of
different alloys can cause the TR-EVO to malfunction with possible temperature
instability and/or dangerous overheating.
1