USER GUIDE
Pneumatic Blind Stapler
TOP SP P, TOP B P
Page:
8
Version:
0711
ET 572
Page 8 of 10 18.10.11 P:\Technik\TOP\Bedienungsanleitung\Englisch\Operation Instructions TOP P 0711.DOC
Before the start of all major maintenance and cleaning, all safety precautions must be taken and the
pressurized air supply must be switched off and disconnected.
The following work processes/inspections should be performed by knowledgeable personnel on a
regular basis:
•
Regular cleaning of the stapling machine
•
Regular oiling of the movable parts (no graphite oil!) - on a weekly basis
•
Check the maintenance unit for condensation. If necessary remove the condensation.
•
The maintenance unit should be set to 1 drop of oil per 30 stapling cycles. (1/8 turn)
•
In case of sluggishness or blockage of the driver, loosen the screws (57 and 58) on the head piece
(51) thus releasing any possibly present stress in head-piece and then tighten these screws firmly
again.
•
Cleaning of cardboard dust
Only ORIGINAL spare parts may be used. (see “spare parts list”)
Failure to comply will void any guarantee claim and exclude any liability!
Only original spare parts are subjected to our quality control. To ensure a safe and reliable operation,
only spare parts from the manufacturer may be used.
All technical equipment, especially the safety equipment, must be inspected by professional staff after
a modification or repair.
8.1
Reloading of TOP staples
Pull the transport puck (9) back and upwards until it snaps in. After
inserting the 3 staple strips (120 staples) gently press down the
transport puck (excessive force will cause a rupture of the transport
bands and a breaking of the staple strips) and bring it into a tensioned
position.
09
57
51
58
