Pneumatic table stapler
TH 210
Page:
8
Change:
02/2019
ET
598
Page 8 of 12 21.02.19 P:\Technik\TH_THE_210\Bedienungsanleitung\Englisch\BA TH 210 02_2019_EN.docx
14
Setting the stapling device
Lateral staple spacing
The insert staplers can be adjusted to the
desired stapling dimensions. To do this,
loosen the three screws
V1
to move the
insert stapler and the associated stapling
cylinder with the
L
strip. Ensure that the
cylinder is centered on the insert stapler
plate. Tighten the screws again. The
stopper on the right is fixed with screw V2
in the corresponding position.
Insertion depth
Loosen the two screws
V3
and slide the
rear stopper to the desired position.
Stopper,
right, loosen with screw
V2
and move.
Tighten the screws again.
15
Error detection
During any kind of fault, the stapling device is to be shut down and separated from
the pressurized air supply until the flawless operation is ensured again.
Please
do
not
try
to
dismantle
or
repair
the
stapling
device.
In the event of a malfunction, which is more extensive than just some jammed
staples, please contact us. The stapling device will be examined by our
specialists and the malfunction will be remedied.
Remove
all
staples in the stapler and clean the stapling device.
Remove visible staples in the staple outlet opening with a suitable tool. Do not overload or damage
the device thereby! In difficult cases, open the magazine and pull out the staples upwards.
Make sure that the clamp outlet opening is not damaged.
Replace damaged or worn stapling devices.
Connect the compressed air again
Make sure that the air pressure is set correctly and that manual slide valves are open
V1
V1
Stopper,
right
V3
Insert
stapler
Maintena
nce unit
V2
Insert
stapler
plate
Counte
r
Impulse
valve
