Meyra SMART 9.906, Operating Manual, Page: 21 / 68

2
3
1
21
BACK SUPPORT
The back support can be folded down
for storage or transport.
☞
Note:
For better demonstration of the
wire cable (1) the back support is
shown without cushion.
Folding over the back support
– If required remove the seat cush-
ion (velcro fastener).
– Disengage the back support by
pulling or pressing the wire cable
(1) at its centre and fold it onto the
seat (2).
Folding up the back support
– For this raise the back support and
pull the pressure bolts inward by
pulling or pressing on the wire ca-
ble (1).
– Release the wire cable in order to
lock the back support in the de-
sired position (3). – The pressure
bolt must audibly lock into place.
– If required replace the seat cush-
ion.
☞
Note:
☞
The greasing of the thrust bolts is
recommended for an easier latch-
ing of the back support.
☞
Check the lock of the back support.
Adjusting the back support angle
– Unlock the back support by pulling
or pressing the centre of the wire
cable (1).
– Release the wire cable in order to
lock the back support in the de-
sired position (3). – The pressure
bolt must audibly lock into place.
☞
Check the lock of the back support.