1
2
3
3
4
5
20
BACK SUPPORT
The angle of the back support (1) can be ad-
justed through the operating module.
☞
Note:
For adjustment view chapter <
Mode-
menu
> in the operating manual <
Op-
erating module
> resp. chapter
on page 9 within this docu-
ment.
☞
View chapter
HEAD SUPPORT
The head support (2) is swivel proof, height
and depth adjustable as well as removable.
Adjustment of the head support
After loosening the clamping levers (3) the
head support can be adjusted to the de-
sired position.
Afterwards retighten the clamping levers (3).
Removing and height adjusting
the head support
Loosen the clamping screw (4) to remove
or adjust the head support. Either remove
the head support or slide it to the desired
position. Afterwards retighten the clamping
screw (4).
Adjusting the head support dur-
ing handicapped transport inside
a motor vehicle
A correctly adjusted head support reduces
the risk of whiplash injury during a rear-end
collision.
The head support should be adjusted so
that you can fit at maximum a flat hand be-
tween the rear end of the head and the sup-
port surface. The upper edge of the head
support should be adjusted slightly above
or at least level with the top of the head.
Holder for chin operation
The holder (5) exists for example in combi-
nation with the chin operation.
