Meyer's VB375, Instruction And Parts Book

Page: 20 / 56

MODEL: VB375 Page 20
L5
Grease the apron drive shafts, both sides of the
spreader by the grease lines, 5 pumps every 8
hours. Figures 11 and 12.
Grease the axle at both sides of the spreader
by the grease lines, 10 pumps every 8 hours.
Figures 11 and 12.
Maintain oil level in vertical beater gearbox to
site gauge level. It holds 7.25 Qts. When required,
refill with SAE 85-140 Moly Fortified gear lube or
Synthetic SAE 75-90 gear lube. Figure 12.
Grease cross bearings on yoke (both ends of
PTO shaft) 1 pump every 8 hrs. Grease telescoping
shaft through slot in center of guard, 4-5 pumps
every 8 hrs. Figure 15.
Special attention should be paid to lubricating the
constant velocity PTO drive shaft assembly. See
figure15.
L9
L9
L10
CV CENTER
HOUSING, 4 PUMPS
EVERY 24 HRS. OF
OPERATION
L10
CV BALL & SOCKET,
1-2 PUMPS EVERY 8
HRS.
FIGURE 15. PTO LUBRICATION
L3
FIGURE 14.
NOTICE!
SPREADER MUST BE SITTING
LEVEL FOR AN ACCURATE OIL
CHECK.
TO CHECK OIL LEVELS, PARK
SPREADER ON LEVEL GROUND,
AND USE JACK TO RAISE / LOWER
THE SPREADER BODY UNTIL IT IS
COMPLETELY LEVEL.