MEWOI MEWOI1310B, User Manual, Page: 13 / 16

9
15 minutes of the receiver of the detector power on, the LCD continues to blink , indicate that
will automatic shutdown. The LCD will automatically shut down after 30 seconds of continuous
flashing to reduce battery consumption. In case of LCD continuous flashing and press POWER
key, the meter will continue to work.
Under HOLD mode, press POWER key to power off.
Under data access mode, first long press POWER key ( over 3 seconds ) to exit data
access mode, return to data receive mode, press POWER key again to power off. During exit
from data access will display “
End
” symbol.
6.2.2. Data Reception
The receiver is in receiving mode after normal startup. If there is transmitted data, the
receiver will display the test results in real time. If no signal is received, the receiver will
continuously search for the signal and dynamically display the "no--" symbol.
6.2.3. Data Hold
In the mode of receiving data, press HOLD
key can keep LCD display , and “
HOLD
”
symbol indication. Press HOLD key again to cancel data lock state, return to receiving data
mode, “
HOLD
” symbol disappear.
6.2.4. Data Storage
In the mode of receiving data, press the HOLD key to hold the data while the receiver
automatically numbers and stores the present hold data, and the " MEM " symbol flashes once in
the stored process. The receiver can store 99 groups data, if the storage is full,
“
FULL
” symbol
will continue flashing display, memory must be cleared and then could store again.
6.2.5. Data Access
In the mode of receiving data, press HOLD + POWER key enter into data access mode,
“
MR
” symbol display while will automatically display storage data of the group 1. Then press
HOLD key or POWER key to read the stored data by turning upward or downward in cycle.
Automatically returns the first group of data when browse to the last group of data stored.
Long press POWER key (over 3 seconds) to exit from data access mode, return to
receiving data mode. During the exiting display “
End
” symbol.
6.2.6.Data Delete
In data access mode, press HOLD + POWER key to delete all storage data, and return to
data receive mode. During
the deleting data display “
dEL
” symbol.