- 52 -
Personal Preferences (
)
All the preset values will be restored, when
pressing "
".
33
Sound Indicator
The alternatives of the indicator are Mono,
Stereo, Dual I and Dual II. This indicator is
displayed under the programme number in-
dicator on the screen. "
I-II
" button is used to
select Mono or Stereo, or Dual I or Dual II.
0212
In Mono broadcast or in forced-mono (for
stereo broadcast).
67(5(2
In Stereo
broadcast.
'8$/,
If dual broadcast detected. Dual I is selected
in default and also can be selected after
Dual II by Remote Control.
'8$/,,
If Dual II selected by Remote Control.
Picture Mode
Picture mode OSD is displayed when
button is pressed. Picture mode can be
changed to
Auto, 4:3
or
16:9
by pressing
button.
Sleep Timer Indicator
It is displayed on the upper right of the
screen when a new programme is entered
by digit button or by pressing
,
P-,
P+
,
TV
,
AV
button. If sleep timer is acti-
vated it is displayed with the TV status and
erased with it after 3 seconds.
After the setting time of sleep timer has
passed then TV goes automatically to stand-
by.
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is
disabled.
To cancel mute, there is two alternative; the
first one is pressing to " " button, this vol-
ume is set to the preceding value, and the
second one is increasing the volume level,
thus it starts at the minimum level to in-
crease. By decreasing the volume level in
mute state, mute will not be ignored, only the
volume level will decrease. If mute canceled
after decreasing the volume level, the vol-
ume will valid with the decreased level.
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes
for the switching to the Stand-By mode un-
less any signal detected or no any Remote
Control command is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized
to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
No-Signal Detection (PC)
If no valid signal detected for 5 minutes sys-
tem goes to Stand-By mode. To switch on
the system press button.
As the last status feature, system starts from
TV or PC, whichever was the status before
stand-by or switch-off. Note that SCART in-
puts have the precedence on both TV and
PC.
