IMO 3/20
6
IMO-502 EN
NOTE: It is advisable to replace all the rubber parts using
genuine RMEBS spare kit. Numbers in parentheses, ( ) indicate
the bubble number (reference number) used on the RMEBS
Assembly details and Part List. For disassembly of single
acting cylinder follow the sequence. For disassembly of
double acting cylinder just ignore 1st step from heading 7.2.
Piston disassembly, remaining sequence is same as given.
7.1
Front cover disassembly
1. Remove lock nut (7), Loosen the cylinder cover bolt (9)
of front cover and remove it.
2. Remove rod seal (14) using screw driver.
3. Remove o-ring (17) and cushion seal (15), take out
cushioning screw (12) wiith o-ring (19) from front cover (1).
4. Clean it with liquid soap solution. After drying apply
grease on rubber parts. Replace these rubber parts.
5. Pull the piston rod (5) with piston subassembly outside
the tube (3).
6. Just push tie rod (6) and take it away with cover nut (9)
from rear cover (2).
7.2
Piston disassembly
1. Take out SHC screw (8) from piston (4) to disassemble
rod (5).
2. Remove lip seal (16) and buffer cap (10) from piston (4).
Use blunt needle to remove lip seal (16).
Summary of Contents for JAMESBURY CC Series
Page 11: ...IMO 3 20 IMO 502 EN 11 ...
