METROTEC
34
Notes on the correction:
§
The additive value will be used to adjust the display to 20.9 % when correcting
the oxygen.
§
For this purpose the sample gas input will be kept open when the sample gas
pump is switched on so that ambient air will be sucked in. The result of the
correction is shown on the right half of the display. The multiplicative value will
be entered, when correcting the oxygen with the sample gas connected, and
adjusted to the sample gas value (the additive correction value should not be
changed when sample gas is used).
§
The correction values additive = 0.0 and multiplicative = 1.0 mean: Correction
has no impact.
8.3 Setting the Alarms
Ø
The beeper integrated in the measuring device is activated or deactivated.
(See menu line No. 29. )
A definition is made whether the respective alarm for the measured value will
be activated or deactivated. (See menu line No. 30, 34, 38, 42, 46, 50, 53, 56.)
Ø
A definition is made for how long a pending alarm will be suppressed bevor
being reported. (See menu line No. 31, 35, 39, 43, 47, 51, 54, 57.)
Ø
In case an alarm evaluation had been activated, the upper and lower alarm
limit will be entered. (See menu line No. 32, 33, 36, 37, 40, 41, 44, 45, 48, 49,
52, 55, 58, 59.)
8.4 Setting the Trend Graphic Window
Ø
The time axis for each selection of a measured value will be determined. (See
menu line No. 10, 13, 16, 22.)
Ø
The axis fort he upper and lower measured value displayed will be
determined. (See menu line No. 11, 12, 14, 15, 17, 18, 23, 24.)
8.5 Definition of Analog Outputs
Ø
The output hub for 0 – 20 mA or 4 – 20 mA must be selected. (See menu line
No. 61.)
Ø
A measured value selection will be allocated to analog output 1. (See menu
line No. 62.)
Ø
A measured value selection will be allocated to analog output 2. (See menu
line No. 63.)
Ø
The value to be put out at 0/4 mA will be determined. (See menu line No. 66,
68, 70, 72.)
Ø
The value to be put out at 20 mA will be determined. (See menu line No. 67,
69, 71, 73.)
