Metrologic 19-07335, Installation Manual

Page: 5 / 32

1
I
NTRODUCTION
The IS4800 microQuest
®
series are miniature single-line scan engines designed
for direct integration into customer decode-equipped OEM devices.
The microQuest non-decode scan engine is equipped with a multitude of
features including:
• 100 Scans per Second, Typical.
•
Support for 3.3VDC Input Voltage (IS4813 Model)
•
Support for 5VDC Input Voltage (IS4815 Model)
• A 650 nm Bright Laser Diode
•
A narrow exit angle to provide precision beam positioning.
• Automatic (Hardware) Scan Sense
•
A rugged industry standard size die cast chassis with threaded mounting
holes.
•
A 10-pin ZIF Connector Industry Standard Pinout for Seamless Integration
into Portable Devices
•
Low Mass (11 grams) Industry Standard Size
The manufacturer of the end equipment must register with agencies such
as the Food and Drug Administration (FDA). The specifications required
for registration are not obtainable until the OEM manufacturer uses the
microQuest Engine in its final configuration.
Therefore, it becomes the
responsibility of the manufacturer who incorporates the scan engine into
their product to comply with all federal laser safety regulations.
The manufacturer must submit a Laser Product Report for the FDA in the
US. Metrologic will assist its customers in complying with the necessary
procedures.
THIS DEVICE DOES NOT COMPLY WITH 21 CFR 1040.
USE ONLY AS COMPONENT.
Caution: The laser is susceptible to permanent damage if enabled less
than 50 ms after the Scan Enable has been activated. This requirement
must be strictly adhered to or the limited warranty on page 23
is void.
Refer to Scan Sense Timing on pages 16 - 17 for additional information.
M
ODELS AND
A
CCESSORIES
Model Description
IS4813 Non-Decode, 3.3VDC Scan Engine
IS4815 Non-Decode, 5VDC Scan Engine
19-07335 10-pin Flex Cable