metrofires LTD Insert, Installation & Owner'S Operation Manual, Page: 3 / 16

3
Diagram 2
Bottom
Louvre
Ashlip
Door
Carton
Diagram 2A
Bottom
Louvre
Ashlip
Trend fascia’s are supplied partly assembled, and require the
ashlip and bottom louvre to be fitted as illustrated in Diagrams
2 and 2A below. To assemble, proceed as follows: -
• On a large flat surface (a soft floor) slide the fascia out of
the carton, front face down and remove the door which is
packed into a separate carton located in the centre of the
fascia.
• Re-close the flaps of the fascia carton and lay the fascia
front down on top of this now empty carton.
• Remove the two sections of tape securing the ashlip panel
to the rear face of the fascia as detailed in Diagram 2.
Carefully lift the ashlip panel away from the fascia and
place it gently to one side.
• Remove the four screw’s and bottom louvre as illustrated in
Diagram 2.
• Reposition the ashlip into its final position as illustrated in
Diagram 2A taking particular attention to ensure:
- The ashlip is the right way around.
- Do not mark the coating on the ends of the ashlip panel
as you slide it into the fascia, you may need to slightly prise
apart the fascia side panels as you fit the ashlip.
• Position the bottom louvre as illustrated in Diagram 2A and
refit the four screws previously removed.
The fascia is now completely assembled and ready for
installation. When moving the fascia, hold it at both sides to
avoid “twisting” the fascia which may cause the enamel to
chip.
Assembling the fascia