!
NOTE:
Never allow the two battery pack
terminals to make contact!
This tube counter can be installed in a variety
of ways, depending on your data collection
goals. The most common approach, resulting
in the best achievable classification and count
accuracy is the
Classifier Sensor Layout
(two
tubes of equal length, of equal length from
the kerb to the counter, parallel to each other,
spaced one meter apart).
Counter installations should be done by skilled
and, where possible, duly qualified personnel.
An adequate supply of simple, yet high-quality
tools is essential for safe, speedy tube setup. A
minimum set includes:
!
NOTE:
Installers and users should
ensure that they have referred to and
have regarded all relevant statutes and
regulations in force in the locality where
installation and use are to be made.
Steps to main battery replacement
1. Using the supplied 4mm hex driver, remove
the six screws from the unit’s lid.
2. Remove the lid.
3. Lift the existing battery pack from the base.
4. Disconnect both battery pack terminals.
5. Connect the new battery pack,
ensuring
you colour-match the leads
; the counter is
protected against reverse polarity.
6. Place the new battery pack centrally in the
battery compartment.
7. Neatly route each battery lead on opposite
sides of the pack, ensuring the leads are not
caught under.
8.
Reposition the lid, ensuring it is correctly
aligned with the Status LEDs.
9. Replace the lid screws. Make sure not to
over-tighten them; a quarter turn past the
point that the lid mates with the base.
10. After changing the battery pack, a warning
message might appear. This is perfectly
normal and will disappear the next time the
unit is setup.
Connector tips
The battery tab connectors used in the
RoadPod VT counters are designed for
maximum reliability. Some tips on how to use
them:
•
The terminals are best separated using a
rocking, side-to-side action.
•
Always grip the terminals; try to avoid
pulling on the leads.
• Consider using a pair of pliers to grip the
terminals.
•
When reconnecting, the terminals should
click into place.
RoadPod
®
VT installation
•
Small mallet / heavy duty claw hammer /
electric drill
•
Crowbar
• Side cutters or pliers
•
Chalk or lumber crayon
•
Tape measure or 1m stick
•
High-quality safety equipment
www.metrocount.com
MetroCount
Traffic Data Specialists
®
Page 3