Display the Version Number:
Reconfigure Memory:
To reconfigure the memory:
- Press OK to wake up touchpad.
- Enter Service Code and press OK.
The version number identifies the touchpad software version.
- Press "FUNCTION" key several times until "DISPLAY THE VERSION
NUMBER" is displayed.
- Press OK and the version number will display.
- Press OK.
- Press "SIGN OUT" to exit Service Mode.
All system IDs and system configurations are stored in the
EEPROM memory. To prevent an inadvertent choice of this test that
will erase EEPROPM memory, this function choice is hidden. It is only
displayed if the touch pad printed circuit board is exposed and the
Service switch (lower left corner of the circuit board) is simultaneously
pressed.
After executing this function, only the default codes will remain in
memory. These include Set-up (311) and Service (911). All other IDs
(user and supervisor) will be lost.
- Allow the cart to 'go to sleep'.
- In the bottom of the cart, on the printed circuit board, press and hold
the "S2" switch located on the front left-hand side of the board.
- While holding the "S2" switch, press OK to wake up the touchpad.
- Still holding the switch, enter "911" and press OK.
- Follow prompts to erase memory.
- Release the "S2" switch.
- Press "SIGN OUT" to exit Service Mode.
Note:
Note:
The Reset Switch allows for quick electrical recovery when the touch
pad is not responding. The reset switch is located on the back of the
cart.
Before using the switch, ensure that the cart is unplugged from
the charger.
- Press the reset switch on rear of cart.
- Release switch.
- Power should be restored.
- If power is not restored, repeat the steps above.
- Shut off rocker switch to disconnect power to the touchpad.
- After 30 seconds, turn switch on to restore power to the touchpad.
Note:
To Use Reset Switch (push-button style):
To Use Reset Switch (rocker style switch):
FL420
Electronic Locking User Guide - General Operating Instructions
Section 10: Reset Switch
Important:
Always adjust the Servomotor after reconfiguring memory. The
battery levels will not have to be reconfigured but you should
check these levels as described elsewhere in this manual.
North Washington Street, Wilkes-Barre, PA USA 18705
For Product Information, Call
or
1-800-992-1776
570-825-2741
Information and specifications are
subject to change without notice.
Please confirm at time of order.
L01-460
3
/11
R
InterMetro Industries Corporation
6