CS 2099 Eurocheck
Eurocheck description and maintenance
6
3 Eurocheck description and maintenance
3.1 Front panel
5
0
M
5
1
5
L
N
R
C
D
L
O
O
P
+
1
L
O
O
P
+
1
1
O
U
T
P
U
T
5
0
V
A
C
E
u
ro
c
h
e
c
k
C
S
2
0
9
9
S
E
L
E
C
T
R
C
D
L
O
O
P
0
.5
2
M
C
O
M
Figure 3.1: Front panel
Legend:
1 ...........Insulation calibration outputs.
2 ...........Low
Ω
and continuity calibration outputs.
Caution – do not use test currents higher than 200 mA.
3 ...........Power supply cord connection polarity indication.
LED lights if L and N lines are incorrectly connected – reverse connection.
4 ...........Incorrect test current indication for RCD trip-out time function verification
(appropriate LED lights if test current is too low or too high).
5 ...........RCD test calibration function selected.
6 ...........Fault loop calibration function selected (each LED indicates sub-function), also
used for trip-lock/line impedance calibration.
7 ...........LED lights if voltage is present at RCD/Fault loop calibration output.
Press RCD/LOOP selection button (9) once after connecting the calibrator to
the power supply to enable voltage at output connector.
LED goes out whenever RCD simulator trips and is automatically restored 3
seconds afterwards (other LEDs remain lit during this period).
8 ...........RCD/Fault loop calibration output (used for fault loop/trip-lock/line impedance
and RCD trip-out time calibration).
Caution – line voltage present on test terminals!
Consider specified duty cycle when calibrating fault loop or line impedance
to avoid overheating of Eurocheck.
9 ...........RCD/Fault loop selection button.
Press repeatedly to cycle through available options: enable output, LOOP+11
Ω
, LOOP+1
Ω
, RCD, disable output.
10 .........Voltage/frequency calibration output.
10
9
5
1
2
3
4
6
7
8
Note:
Output connector
type is country
dependent.