4. For DC measurement, output is positive in the red plug when the current flows from the lower side to the upper
side of the current clamp as shown in Figure 2. (Upper side of the current clamp is facing the positive measurement
contact)
5. Press the trigger to open the transformer jaws and clamp one conductor only, make sure that the jaw is firmly
closed around the conductor, then read the display from the multimeter directly.
Figure 2
M
AINTENANCE
TO AVOID ELECTRICAL SHOCK REMOVE TEST LEADS BEFORE OPENING THE COVER.
General Maintenance
1. Repairs or servicing not converted in this manual should only be performed by qualified personal.
2. Periodically wipe the case with a dry cloth and detergent do not use abrasives or solvents.
Battery Installation Replacement
The meter is powered by a single 9V battery. Refer to Figure 3 and use the following procedure to replace the battery.
1. Disconnect the output plugs and turn the meter off.
2. Position the adaptor face down and remove the screw on the cover of the battery compartment.
3. Unsnap the battery compartment and remove the battery.
4. Install a new 9V battery and refit the battery compartment.
