1
Electronic Lock Components.
•
Lock Body
•
Strike (Grey plastic block)
•
Strike loop (Stainless steel wire loop)
Image of Electronic Lock:
Image of Strike and Strike loop:
Electronic Lock Description.
The Electronic Lock body is mounted inside the Locker, while the Door Strike is mounted on the Locker door.
Each Electronic Lock is connected to the Locker Controller electronics board(s) by way of a six wire flat ribbon cable.
Mounting Screws.
Use Pan Head screws only.
No Countersunk screws are to be used.
Damage to the lock can occur and this is not covered under warranty, if the wrong type of screws are used.
Stainless Steel PH2 screws are recommended for harsh environments or Zinc plated for office areas.
•
32 mm 6g for Front of lock (x2)
•
25mm 6g for Rear of lock (x2)
•
16mm 6g for Strike
–
Mounted to locker door (x2)
•
4mm Washers for Strike screws (x2)
Summary of Contents for Metra Electronic Lock
