17
Adjusting the Door Ejector spring force on the Electronic Lock body.
Depending on the door size and hinge types, the Lock Door ejector spring force may need to be increased or decreased.
The Door Ejector is an important part of the Electronic Lock and should be able to push the Locker Door open when
unlocked.
For the great majority of Locker hinges and Locker Doors, the default factory set spring force is adequate.
However if the Locker Doors are very small, or large and heavy, the Door Ejector spring force may need to be adjusted.
This is achieved by screwing in a 2.5/16 mm long self-
tapping countersunk screw into position “A” or “B” on the Electronic
Lock.
–
Make sure the screw head is flush and not protruding. - See below.
Summary of Contents for Metra Electronic Lock
