Page 3
Door Access Terminal Combo Technical Manual
Door Access Terminal Combo
Technical Manual
Manufacturer:
Metra inženiring d.o.o.
IOC Trzin
Špruha 19
SI-1236 Trzin, Slovenia
phone:
fax:
web:
+386 1 56 10 740
+386 1 56 10 744
www.metra.si
System:
Metra Access Control System
Product Group:
Door Access Terminal Combo
Types:
DLCIS
(ISO14443A/B, ISO 15693)
DLCLF
(LF Multitag)
DLCMF
(Mifare, ISO14443A/B)
Year of Construction:
2011 - 2012
Declaration of Conformity:
Metra Access Control products have been developed, designed and
manufactured in accordance with the EU directive for
Electromagnetic
Compatibility (2004/108/EC)
.
Door Access Terminal Combo Technical Manual
[rev.0-050912]
2012 Metra inženiring d.o.o.
All Rights reserved.
No part of this manual may be reproduced in any form or by any means without prior written permission of Metra inženiring d.o.o.
The contents of this manual are subject to change without notice.
All efforts have been made to ensure the accuracy of the contents of this manual, however, should any errors be detected, Metra inženiring would greatly appreciate being informed of
them. Metra inženiring d.o.o. can assume no responsibility for any errors in this manual.
Product description
Door Access Terminal Combo (DAT Combo) is designed to
form a one-way check point in Metra Access Control
Systems and Electronic Locking Systems.
In Access Control Systems a RFID media is used as a door
key. For higher security (e.g. outside door, etc.) a user
specific PIN code as an addition to RFID media can be used.
In Electronic locking systems a RFID media or a locker
number followed by a locker’s PIN code can be used as a
door key.
When access is granted device gives a single relay signal for
access mechanisms such as electric door strike, automatic
door, etc. Normally it is mounted near door where passage
control is needed.
Door Access Terminal operates on line with Metra software.
It must be connected to Metra NET Network.
Passage on Door Access Terminal Combo for particular RFID
ticket can also be externally controlled by 3rd party SW via
TCP/IP software interface.
Operating parameters are defined in the Metra software.
Event data from device is used for further analyses with this
software.
