CHRYSLER
300 2005-2007
ASPEN 2007
DODGE
CALIBER 2007
CHARGER 2005-2007
DAKOTA 2005-07
DURANGO 2005-2007
MAGNUM 2005-2007
RAM 2006-2007
JEEP
COMMANDER 2006-2007
COMPASS 2007
GRAND CHEROKEE 2005-2007
PATRIOT 2007
CONNECTIONS TO BE MADE ON THE
14 PIN HARNESS
1.
Connect the
blue/white
wire to the radio’s amplifier turn-on wire.
2.
Connect the
red
wire to the radio’s Igniton or accessory wire.
3.
Connect the RCA cables to the radio’s RCA outputs. If no RCA outputs are
available, use the Metra line output converter, part # ALOC648,
(SOLD SEPARATELY).
4.
The
white
RCA goes to the left front RCA output of the radio.
5.
The
gray
RCA goes to the right front RCA output of the radio.
6.
The
green
RCA goes to the left rear RCA output of the radio.
7.
The
purple
RCA goes to the right rear RCA output of the radio.
The following wires on the 14 pin harness are for the aftermarket radios
that have navigation built in:
Connect the
Brown
wire to the mute wire of the aftermarket radio.
Connect the
Green
wire to the parking brake wire of the aftermarket radio.
Connect the
Blue/Pink
wire to the VSS or speed sense wire of the aftermarket
radio.
Connect the
Green/Purple
wire to the reverse wire of the aftermarket radio.
• When completed, plug the 14 pin harness into the CHTO-01.
INSTALLING THE CHTO-01
1.
With all connections completed to the aftermarket radio, plug the 22 pin
connector into the vehicles corresponding wiring harnesses.
2.
Cycle the key by turning the ignition on then back off, then back on again
to test the radio.
TESTING THE CHTO-01
1.
Turn the ignition on then the radio to verify the radio works. Check balance
and fader controls for proper operation. If controls are backwards, check to
see if the RCA’s are in the correct location.
2
1
CHTO-01
WIRING UP THE CHTO-01
* Important:
Before beginning any of the following, disconnect the negative
battery terminal to prevent accidental short circuit.
**NOTE: THE ACCESSORY POWER SOURCE OF MOST ALL CHRYLSER VEHICLES KEEPS
THE RADIO ON UNTIL ONE OF THE DOORS IS OPENED. THIS IS CALLED R.A.P.
(RETAINED ACCESSORY POWER). THE CHTO-01 IS DESIGNED TO RETAIN THIS FEA-
TURE.
* NOTE: THE VEHICLES IGNITION SWITCH MUST BE IN THE OFF POSITION BEFORE
PLUGGING THE CHTO-01 MODULE IN. ALSO THE KEY MUST BE CYCLED AT A MEDIUM
PACE AT LEAST TWO TIMES BEFORE BEGINNING TESTING.
CONNECTIONS TO BE MADE ON THE
22 PIN HARNESS:
1.
Connect the
yelow wire
to the radio’s 12v battery or memory wire.
2.
Connect the
black wire
to the radio’s ground wire.
3.
Connect the
orange wire
to the radio’s illumination wire. if wire is not present,
tape up wire.
4.
For the
Caliber only
, connect the
blue/white
wire to the
blue/white
wire in
the 14 pin harness, which connects to the radio’s amplifier turn-on wire.
3
APPLICATIONS
