REV. 3/6/2020 INST99-9613WR
7
ASWC-1 INSTRUCTIONS
(CONT)
WIRING INSTRUCTIONS
From the wiring harness provided to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Red
wire to the accessory wire.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
•
For the radios listed below:
Connect the
3.5mm adapter
provided to the male 3.5mm SWC
jack. Any remaining wires tape off and disregard.
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/White
wire of the connector. Then connect the remaining steering wheel control wire, normally
Brown/White
, to the
Brown
wire of the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire (
Gray
) to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/Yellow
wire
to the
Brown
wire.
•
Note:
If your
Kenwood
radio auto detects as a JVC, manually set the radio type to
Kenwood
. See the instructions under changing radio type.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the
Brown
wire of the connector. Then connect the remaining steering
wheel control wire, referred to as Key-B or SWC-2, to the
Brown/White
wire of the
connector. If the radio comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information
.
•
For all other radios:
Connect the 3.5mm jack into the jack on the aftermarket radio
designated for an external steering wheel control interface. Please refer to the aftermarket
radios manual if in doubt as to where the 3.5mm jack goes to.
Continue to Final Assembly
1.
Push the
12-pin ASWC-1 harness
into the
enclosure
cap
.
2.
Connect the
12-pin ASWC-1 harness
to the
circuit board
within the enclosure, then clip the
cap/harness onto the circuit board enclosure.
3.
Remove the rubber cover from the enclosure during programming to see the LED for
feedback. After the interface has been programmed and tested, install the cover back onto
the opening of the housing.
ASWC-1 INSTRUCTIONS
