REV. 3/6/2020 INST99-9613WR
11
HANDLEBAR CONTROL SETTINGS
(CONT)
Dual Assignment (long button press)
The ASWC-1 has the capability to assign two functions to a single button, except Volume-
Up and Volume-Down. Follow the steps below to program the button(s) to your liking.
Note:
Seek-Up and Seek-Down come programmed as Preset-Up and Preset-Down for
a long button press.
1.
Turn on the ignition but do not start the vehicle.
2.
Press and hold down the handlebar control button that you want to assign a long
press function to, for ten seconds, or until the L.E.D. flashes rapidly. At this point
release the button; the L.E.D. will then go solid.
3.
Press and release the Volume-Up button the number of times corresponding to the
new button number selected. Refer to the Dual Assignment Legend. The L.E.D. will
flash rapidly while the Volume-Up button is being pressed, and then go back to a solid
L.E.D. once released. Go to the next step once the Volume-Up button has been pressed
the desired number of times.
Caution:
If more than ten seconds elapses between pressing the Volume-Up button,
this process will abort, and the L.E.D. will go out.
4.
To store the long press button in memory, press the button that you assigned a long
press button to (the button held down in Step 2). The L.E.D. will now go off indicating
the new information has been stored.
Note:
These steps must be repeated for each button you would like to assign a dual
purpose feature to. To reset a button back to its default state, repeat Step 1, and then
press the Volume-Down button. The L.E.D. will go off, and the long press mapping for
that button will be erased.
* Not applicable in this application
Dual assignment legend
1
- Not allowed
2
- Not allowed
3
- Seek-Up/Next
4
- Seek-Down/Prev
5
- Mode/Source
6
- ATT/Mute
7
- Preset-Up
8
- Preset-Down
9
- Power
10
- Band
11
- Play/Enter
12
- PTT
13
- On-Hook
14
- Off-Hook
15
- Fan-Up
16
- Fan-Down *
17
- Temp-Up *
18
- Temp-Down *
