99-9013HG
Kit Assembly
ISO DIN radio provision with pocket
1.
Cut and remove the (2) plastic
shaded areas from the sub dash.
(Figures A, B)
2.
Slide the
radio housing
into the dash
cavity and push in to engage the
clips to the sub dash. (Figure C)
3.
Remove the metal “DIN” sleeve and
trim ring from the aftermarket radio.
4.
Attach the
radio brackets
to the
radio using the screws supplied
with the radio. (Figure D)
5.
Screw the
into the radio
and bracket assembly using
(4) #8 x 3/8” screws supplied with
the kit. (Figure D)
6.
CAUTION!
The airbag light must be
plugged in before the ignition is
cycled on. Failure to do so will
cause an SRS (Airbag) fault that
can only be turned off by the
dealership.
Locate the factory wiring harness
in the dash and make all necessary
wire and antenna connections.
Metra recommends using the
proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation
Continued on next page
(Figure D
(Figure A)
(Figure C)
(Figure B)
Remove this
shaded area first
Remove this shaded area
second. It is behind the first
piece that was removed.
