99-7627HG
Axxess Interface Installation
• Retains factory screen
• Retains factory back up camera
• Retains factory AUX-IN
• Retains personalization features
• Ability to add aftermarket backup camera or additional video input
• Works in amplified or non-amplified models
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
FEATURES
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
TOOLS REQUIRED
• Axxess Interface
• 7627 harness
• 16, 20, and 32-pin to 12 and 22-pin harness
• 14-pin to 4, 16, and 18-pin extension harness
• 14-pin to 14-pin extension harness wrapped in black tape
• 12-pin harness with (4) RCA jacks
• 20-pin to 24-pin extension harness wrapped in black tape
INTERFACE COMPONENTS
Connections to be made
From the 7627 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Red
wire to the accessory wire.
• Connect the
Orange
wire to the illumination wire. (If the aftermarket radio has
no illumination wire, tape off the
Orange
wire).
• Tape off and disregard the
White/Blue
wire, it will not be used in this application.
The following (2) wires are for an aftermarket multimedia/navigation radio
that provide these wires (if not required, tape them off and disregard them):
• Connect the
Blue/Pink
wire to the speed sense wire
(if applicable)
.
• Connect the
Green/Purple
wire with a
female
bullet connector to the reverse
wire
(if applicable)
.
• Connect the
Green/Purple
wire with a
male
bullet connector, to the
Green/Purple
wire with a
female
bullet connector. Only connect this wire if the
Green/Purple
wire with a
male
bullet connector has a wire populated on the
factory side.