99-6537B
7
Connections to be made
(cont.)
3.5mm jack - steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the included
female 3.5mm connector with
stripped leads
, to the male 3.5mm SWC jack from the
6537 harness
.
Any remaining wires tape off and disregard.
•
Eclipse:
Connect the steering wheel control wire, normally
Brown
, to the
Brown/White
wire of the connector. Then connect the remaining steering
wheel control wire, normally
Brown/White
, to the
Brown
wire of
the connector.
•
Metra OE:
Connect the steering wheel control Key 1 wire (
Gray
) to the
Brown
wire.
•
Kenwood or select JVC with a steering wheel control wire:
Connect the
Blue/Yellow
wire to the
Brown
wire.
Note:
If the
Kenwood
radio auto detects as a
JVC
, manually set the radio
type to
Kenwood
. See the instructions under
changing radio type.
•
XITE:
Connect the steering wheel control SWC-2 wire from the radio to the
Brown
wire.
•
Parrot Asteroid Smart or Tablet:
Connect the 3.5mm jack into the
AX-SWC-PARROT (sold separately), and then connect the 4-pin connector from
the AX-SWC-PARROT into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
•
Universal “2 or 3 wire” radio:
Connect the steering wheel control wire,
referred to as Key-A or SWC-1, to the
Brown
wire of the connector. Then
connect the remaining steering wheel control wire, referred to as Key-B
or SWC-2, to the
Brown/White
wire of the connector. If the radio comes with
a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the
manual provided with the radio for assigning the SWC buttons. Contact the
radio manufacturer for more information.
•
For all other radios:
Connect the 3.5mm jack into the port on the radio designated
for an external steering wheel control interface. Refer to the manual provided with
the radio if in doubt as to where the 3.5mm jack goes to.
4-pin harness with yellow RCA jacks:
• If retaining the factory backup camera to the touchscreen display is desired,
connect the
Yellow
RCA jack labeled “Rearview camera”, to the
Yellow
RCA
jack from the
6537 harness.
• Disregard the
Yellow
RCA jack labeled “AUX video”, it will not be used in
this application.
Continued on the next page
