Metra Electronics 99-5839CH, Installation Instructions Manual

Page: 8 / 32

1.800.221.0932
|
MetraOnline.com
8
With the key in the off position:
1.
Connect the 16-pin harness with stripped leads into port “B” in the
touchscreen display .
2. Connect the 5389 harness into port “A” in the touchscreen display.
3. Connect the 4-pin harness with yellow RCA jacks into port “C” in the touchscreen
display .
4. Disregard ports “D” and “E”, they will not be used in this application.
5. Port “F” is an update port for future Firmware upgrades.
A
B
C
E
F
D
3.5mm jack steering wheel control retention:
• The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the included female 3.5mm connector with stripped leads onto
the male 3.5mm SWC jack. Any remaining wires tape off and disregard:
•
Eclipse: Connect the steering wheel control wire, normally Brown , to the Brown/White wire of
the connector. Then connect the remaining steering wheel control wire, normally Brown/White ,
to the
Brown
wire of the connector
.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire to the
Brown wire.
Note:
If your Kenwood radio auto detects as a JVC, manually set the radio type to Kenwood. See
the instructions under changing radio type.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold separately),
and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• Universal “2 or 3 wire” radio:
Connect the steering wheel control wire, referred to as Key-A or
SWC-1, to the
Brown
wire of the connector. Then connect the remaining steering wheel control wire,
referred to as Key-B or SWC-2, to the
Brown/White
wire of the connector. If the radio comes with a
third wire for ground, disregard this wire
.
Note: After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
• For all other radios: Connect the 3.5mm jack into the port on the radio designated for an external
steering wheel control interface. Refer to the manual provided with the radio if in doubt as to
where the 3.5mm jack goes to.
CONNECTIONS TO BE MADE
(CONT.)
INSTALLING THE INTERFACE