9
INST99-5722
CONNECTIONS TO BE MADE
Attention!
This interface will work with models that are either amplified or non-amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models
without
an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
•
If the aftermarket radio has a mute wire, and the vehicle is equipped with SYNC, connect the
Brown
wire to it. If the mute wire is not connected, the radio will turn off when SYNC is activated
.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
,
Purple/Black
.
From the 5722 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Blue
wire to the power antenna wire.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative output.
• Tape off and disregard the following (1) wire, it will not be used in this application:
Blue/White
with a red connector
• For models with SYNC: Connect the
Red
and
White
RCA jacks labeled “RSE/SYNC/SAT”,
to the audio AUX-IN jacks.
• For models without SYNC: Connect the
Red
and
White
RCA jacks labeled “FROM 3.5”,
to the audio AUX-IN jacks.
• Disregard the DIN jack, it will not be used in this application.
• If equipped with factory subwoofer, connect the
White
RCA jack labeled “SUBWOOFER”,
to the subwoofer out jack.
• Disregard the
Red
RCA jack labeled “CENTER CHANNEL”, it will not be used in this application.
