Meto mn-4, Operating Manual, Page: 31 / 61

30
mn-4203
4.6 Internal Labels
The following sections explain each of the printer’s internally generated
test and configuration labels.
4.6.1 Database Configuration and Dot Check Label
To print the Database Configuration and Dot Check Labels:
With the printer on, loaded with media (at least 4 inches wide), and
ribbon (if printing in thermal-transfer). Press the + buttons
simultaneously to print the Database Configuration and Dot Check Label
Alternately, press and hold the button and turning the printer on,
continue holding the F2 button until the Paused light turns off. Using
this method will initiate the ‘Character Dump Mode’. Turn the printer
off to terminate the ‘Character Dump Mode’.
The first label printed will be the Database Configuration Label, which
lists the printer's configuration and status.
FRI SEPTEMBER 026, 1997 19:29
244
VER: mn-4203 – 01.01 09/30/99
BOOT 83-2279-01A
CODE 83-2280-01A
FONT 83-2281-01A
EXPN
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 2016 KBYTES
SYSTEM RAM AVAIL__ 1264 KBYTES
REG POWER SUPPLY__ NO
INPUT VALUES
PAPER_____________ 255
DARKNESS__________ 131
TRAN______________ 255
REFL______________ 149
RIBM______________ 87
THR_______________ 48
24V_______________ 223
CONFIGURATION
DIRECT THERMAL
COMMUNICATIONS NOT DETECTED
9600,8,N
EDGE
SOP ADJUST________ 128
PRESENT ADJUST____ 128
TOF LOW___________ 0
TOF DELTA_________ 10
TOF GAIN__________ 10
OOS MAXVOLT_______ 2
COUNTER INFORMATION
ABSOLUTE VALUES 9-18-1999
LENGTH____ 773 INCHES
TIME______ 20 HOURS
RESETTABLE VALUES 9-22-1999
LENGTH____ 576 INCHES
TIME______ 10 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE______ 128
SCALABLE FONTS_______ 64
LABEL SIZE 0410:02218 IN