Meto mn-4, Operating Manual, Page: 18 / 61

mn-4203
15
6. Place the Ribbon Hubs back into the printer and route the ribbon
through the printhead carrier assembly as shown below.
Note: The above ‘Right Side View’ shows proper ribbon routing for “ink side
wound-in” ribbons. For “ink side wound-out” ribbons the ribbon supply
hub will rotate in the opposite direction from that shown above. In either
case always make sure the ink side of the ribbon faces the media and
NOT the printhead.
7. The ‘Media Type’ setting within the printer’s setup must be set to
‘Thermal Transfer’ to print using a ribbon. See Section 4.4.