Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
WMKA21005
IMPORTANT
Please read all of the instructions before installation
MA019182
Aroha Shower Mixer
with Diverter
01-9182
Use of this product is recommended for domestic and commercial applications.
All pipework must be thoroughly flushed prior to the installation of the mixer.
Inline filter washers must be installed on both hot and cold supplies to prevent foreign particles
damaging the ceramic cartridge.
Do not remove the ceramic cartridge from the mixer when installing.
Methven recommends a licensed plumber carry out all installations in compliance with
the requirements of AS/NZS 3500. This product complies with AS/NZS 3718 regulations.
JUNE 2012
Installation Guide
www.methven.com
Customer Care Hotline: 1300 METHVEN (638 483)
Email: [email protected]
Installation
1. Screw the body assembly (1) on to the
mounting stud positioned to observe
the installation depth range as follows:
Range of Install Depth, ID = 56 to 74 mm
NOTE: Two sizes of half
dome (5 & 6) are supplied:
Long dome (6) for 56-63mm
Short dome: (5) for 63-74mm
2. Connect body assembly (1) into system and
replace body assembly cover.
3. Cut holes in lining as pictured.
4. Remove plastic template prior to fitting the
faceplate (2).
5. Lubricate the o-ring in the faceplate (2).
Place faceplate (2) over mixer body and
slide firmly over the mixer body until flat on
the wall surface. It is recommended that
a bead of silicone sealant is applied to the
back of the faceplate before fixing to the
finished wall surface.
6. Push inner dome (3) onto cartridge spindle,
fit o-ring (8) and appropriate half dome
(5 or 6) over the body assembly (1) and align
to form of the faceplate. Fit handle (7) and
fasten grub screw with 2.5mm hex key (8).
1.
2.
3.
Plastic
Template
Hot
Cold
5.
6.
4.
Hole cutout
Max 90mm
ID
ø 90mm Max
ø 50mm Min
50mm
25mm
