7
Electrical Connection
•
Before connecting the mixer to an electrical supply, please read the specifications on the rating
plate to ensure that they comply with those of the electrical supply.
•
The machine works off 220/240V 50Hz 1 phase supply and comes fitted with a 3-pin 13amp fused
plug.
•
An electrical supply should be available within the reach of the included power cord.
DO NOT
use
extension cords to connect the machine’s power cord to the electrical supply. The low AMP supply
could damage the mixer or cause a fire.
•
All wiring connections must be checked and tight.
Once the electrical connection has been made, the machine is ready for use.
Operation
Fitting the Bowl
NOTE
: Install the bowl
BEFORE
attaching the agitator.
1.
Lower the bowl lift handle anti-clockwise and down to its resting position.
2.
Lift the bowl by the handles and slowly position the locking pin located at
the rear of the bowl into the hole in the middle rear of the cradle.
3.
Lower the bowl onto the pins located on either side of the bowl cradle.
Bowl Lift & Guard
Move the bowl lift handle anti-clockwise to lower the bowl. It is necessary to lower the bowl to change
the tools, and to provide better access for filling and emptying the bowl. To raise the bowl, move the
bowl lift handle clockwise until it hits the upper stops.
The bowl cradle and guard are electrically interlocked so that the mixer will only operate when the bowl
is in the raised position. In addition to this the bowl safety guard must be locked by rotating into position
(left to right) and the guard is locked in place. This ensures total user safety at all times.
Once the guard has been opened and the bowl lowered the mixer can only be restarted by pressing the
start button.
During operation additional ingredients can be added via the ingredients chute located on the right-
hand side of the bowl guard.
