8
Cleaning Instructions
ALWAYS
disconnect from the power source when cleaning or servicing this machine.
ALWAYS
take care when cleaning parts as grazing and/or abrasion could result from contact with rough
parts
ALWAYS
take care when cleaning sharp components to avoid cuts
NEVER
attempt to clean this machine while it is in motion, serious injury could result.
NEVER
use a scrubber pad, steel wool, or abrasive material to clean the mixer.
NEVER
use bleach or bleach based cleaner.
Part
Recommended Cleaning
Frequency
Parts
Hand wash using soap and water, rinse, dry and sanitise
Clean after each use
Exterior
Wipe with a clean damp cloth, dry & sanitise
Daily
Troubleshooting
Problem
Possible Causes
Action Required
The unit is not working
Power not connected correctly Check the plug
Fuse has blown
Replace fuse (13amp)
Thermal overload triggered
Wait for motor to cool down
Motor is overheating
Voltage is too low
Check voltage
Overload
Reduce volume of ingredients
Blockage
Bone fragments in meat
Disassemble the grinding unit by
loosening the grinding mouth block knob,
not the locking handwheel. Remove the
blockage and reassemble
If the machine is making unusual noises or traces of oil are found on the feed screw or elsewhere, the
machine must be turned off and an engineer visit arranged.
WARNING – IF EQUIPMENT DOES NOT WORK, PLEASE ENSURE IT IS SERVICED BY A METCALFE
APPOINTED ENGINEER