6
Installation
Unpacking
Unpack the mincer immediately after receipt. Please inspect the mincer to ensure no damage has
occurred in transit and that all parts have been provided. If the machine is found to be damaged, keep all
the packaging material and contact us immediately or contact your source of the equipment. Never
attempt to operate the machine with damaged parts. Report any deficiencies to the dealer that supplied
the machine.
You should receive with your mincer:
1 x Meat Mincer
1 x Hopper tray
1 x Instruction Manual
1 x Food pusher
1 x 6mm Extrusion Plate
If the above item was not received with your mincer, please refer to page 9 for contact details and
inform us immediately for replacements.
Before using the mincer, please read this manual thoroughly. Do not proceed with any installation nor
operation if you have any questions or do not understand anything within this manual. Please see
contact details on page 9 for assistance.
Location
Select a location for the machine keeping these points in mind:
•
Position on a flat, stable surface
•
Easy access for cleaning, maintenance and servicing
•
Clearance for operating controls
•
Sufficient space above the hopper to load the meat
•
The work surface or bench must be able to support a load of 55kgs
•
The rear ventilation outlet of the mincer must not be blocked.
Ambient Conditions
•
The minimum requirement for all electrical equipment’s correct operation is an air temperature of
b5
℃
and +40
℃
.
•
Electrical equipment operates correctly when the relative humidity does not exceed 95% at a
maximum temperature of +40
℃
.
•
Electrical equipment operates correctly at altitude up to 1000m.
•
Electrical equipment is designed to withstand and be protected against the effects of
transportation, and storage temperature within a range of -25
℃
to +55
℃
and for short periods not
exceeding 24h at up to +70
℃
.
Electrical Connection
•
Before connecting the mincer to an electrical supply, please read the specifications on the rating
plate to ensure that they comply with those of the electrical supply.
•
The machine works off 400V 50Hz 3 phase supply. Ensure that the feed screw is turning in an anti-
clockwise direction. If it is turning clockwise, switch off the machine, unplug it, disconnect two
phase conductors and invert them.
•
An electrical supply should be available within the reach of the included power cord.
DO NOT
use
extension cords to connect the machine’s power cord to the electrical supply. The low AMP supply
could damage the mixer or cause a fire.
•
All wiring connections must be checked and tight.