Revision 1.0
September 09,2011
MetaWatch_Analog_WDS112_Getting_Started_1.0
14 of 21
Menu Mode Page 3 with all items OFF
2.6
P
AIRING THE
W
ATCH
Since the watch has a small user interface, the initial software is configured so that the pairing procedure should be
started by the other device. Make sure the watch has Bluetooth ON and has Discoverable mode ON before pairing.
There are two methods to pair, the easiest may be to go straight to the Meta Watch Manager application, found on
the Android Market.
2.6.1
Pairing using the MetaWatch Manager for Android
Open the MetaWatch application, go to “Menu->Settings->Select Watch”. A list of discoverable devices will be
displayed. If you do not see the watch at first, double check your Android phone has Bluetooth set to ON and also
that the watch has Bluetooth and Discoverable modes ON. If so and you still can not see the watch, you may need to
move to a less radio noisy environment and try again.
Once you see the watch in the list of discoverable devices, simply tap on the watch (check the MAC address in the
phone list matches what your watch is displaying). This saves the watch address. Next go “Back” and hit “Menu-
>Start”. The MetaWatch service will attempt to connect, if the watch had not been paired previously, then a pairing
request will be displayed either as a pop-up menu or as an item in the notification bar.
The pairing code (for non-SSP mode) is four zeros. Enter “0000” with no quotes. The pairing should complete and
the MetaWatch Manager will finish establishing the connection to the watch.
METAWATCH
A
B
C
F
D