8 Conventional Products—B110LP Plug-In Conventional Low Profile Detector Base
Note: Terminals 2, 3, and 5 do not use looped wire under terminals.
Break wire run to provide system supervision of connections.
T his
N ot Th is
w irg ui de
Figure 2: Electrical Connections
To make wire connections:
1.
Strip insulation from the end of the wire.
2.
Slide the bare end of the wire under the clamping plate.
3.
Tighten the clamping plate screw.
4.
Use the strip gauge molded into the base for ease of wiring
to terminals.
The smoke detectors and mounting bases are marked with a compatibility
identifier located as the last digit of a five digit code stamped on the back
of the product. Connect detectors/mounting bases only to compatible
control units as indicated in the Device Compatibility Technical Bulletin in
the Fire Management Accessories Manual (FAN 445).
