16
OPERATION MANUAL
4.2 OPERATING CONTROLS
The controls for the machine are situated on the roving foot pedal
1
2
3
4
5
6
7
8
9
10
11
12
13
1.` Power Button:
Switches the electrical circuit on
2. Yoto Controller:
Programs the operation (See 4.2 Controller Operation).
3. Emergency Stop:
When pressed switches off the electric circuit of the machine. The red
knob must be twisted to be released before the machine can be restarted.
4.` Dwell Timing:
Sets the amount of delay at the Apron is stationary at the end of the bend
before returning.
5. Manual/Auto Switch:
Selects between either manual of automatic operation.
6. Inch Down:
When pressed lowers the apron when in “Manual” mode.
7. Auto Start:
Once “Auto” (#5) is selected, then when pressed completes one cycle.
8. Bend Up:
When in “Manual “ mode raises the apron when pressed
9. Pump Stop:
Stops the hydraulic pump
10. Pump Start:
Starts the hydraulic pump
11. Open Height:
Sets the opening of the clamp beam when “Auto” is selected.
12. Left Foot Pedal:
When pressed lowers the clamping beam approx 10mm.
13. Right Foot Pedal:
When pressed raises the clamp beam.
22/07/2019
Instructions Manual for PB-422L (S576)
16
