13
OPERATION MANUAL
4. COMMISSIONING
4.1. PREPARATION OF THE MACHINE.
q
Remove all wrapping and packing grease from the machine.
q
Check the machine for loose bolts. Tighten as required.
q
Check the top return position is correct.
q
Clean the blades and tighten the securing bolts as required. Examine the cutting edges of both
blades for damage.
q
Inform your service provider of any damage or faults with the machine.
Warning- Follow all setup instructions before starting the machine
The safety circuit consists of a reset switch and two rear side guards, each having 3 sensors. Your ma-
chine will have a RED warning light on the main control panel. When the main power is switched
on or the rear sensors have been tripped the safety circuit must be reset before the motor can be
started.
Warning Indication: The safety circuit has not been Reset.
4.2 OMROM E3Z SAFETY SENSOR ALIGNMENT
Red Warning Light
Reset Switch
Press the “Reset Rear Guard” button on the back of
the electrical cabinet to reset the safety circuit
Page 13
Instructions Manual for MG-440 (S924A)
07/02/2018
