12
ULMS-Series | Version 2.04
Assembly and Installation
Fig. 9: Installation of the feet on model ULMS 500
7.2 Mounting the second suction
nozzle
For extracting chips from the engine compartment, it is
possible to install a second extraction socket.
Proceed as follows to mount the second suction connec-
tion.
Step 1: Turn the machine off and unplug the power cord
from the wall outlet.
Step 2: Open the cover (Pos.2, Fig.10) on the back of the
machine.
Step 3: Remove the screws and nuts attached to the
strut (Pos.3, Fig.10).
Fig. 10: Assembly of the suction connection part 1
Step 4: Remove the bracing (Pos.3, Fig.11)
Fig. 11: Assembly of the suction connection part 2
Step 5: Mount the suction connection (pos.5, fig.11) to
the strut and the machine using the screws and
nuts.
Step 6: Close the machine cover.
7.3 Electrical Connection
Make sure that the mains voltage matches the specified
voltage level of the information on the rating plate before
connecting your device to the power supply.
Also, when starting the machine, check that the direction
of rotation of the saw matches the direction of the arrow
on the machine.
7.4 Installation of the cutting tool
Replacing the saw blade on the ULMS 420 and
ULMS 500 models
NOTE!
After setting, remove the grease from the bare metal
parts, which has been applied for protection.
- Use usual solvents.
- No water, no nitrolic solvents or similar use!
NOTE!
- It is recommended to leave the device off when not
in use.
- If you need to use an extension cord, make sure it is
sufficiently thick. It is recommended to use an exten-
sion cord that is as short as possible.
- Always disconnect the mains plug before carrying
out any maintenance or repair work.
- Do not leave the unit unattended when it is
connected to the mains.
