Metallkraft KRBS 101, Instruction Manual

Page: 15 / 26

Care, maintenance and overhaul/repair
KRBS 101 | Version 1.03 15
Step 12: After completion of the work on the belt grinding
station, the cover must be closed. To do this,
fold down the work surface after loosening the
fixing screws or remove it.
Then close the cover and tighten the fixing
screw.
9.3 Working position surface grinder
Step 4: Open the cover on the upper side of the device.
Fig. 22: Surface grinding station
Step 5. Check the running direction of the sanding belt.
Step 6. Stop the workpiece at the stop in the running di
-
rection of the belt and guide it against the sand
-
ing belt for processing.
9.4 Shut down the Machine
Step 1: To switch off the Machine, press the red STOP
Button.
Step 2: Switch off the extraction system.
Step 3: Pull the mains plug of the grinding Machine.
10 Care, maintenance and overhaul/re-
pair
Tips and recommendations
In order that the Machine is always in good operat
-
ing status, it is necessary to regularly perform care
and maintenance works.
WARNING!
Danger in case of insufficient quali
-
fication of the staff!
Insufficiently qualified persons cannot estimate the
risks while performing repair work at the Machine
and expose themselves and others to the danger of
severe injuries.
Have all maintenance works only performed by quali
-
fied persons.
DANGER!
Electric shock is life-threatening!
There is a danger of life in case of contact with cur
-
rent running through components.
- Always disconnect the mains plug before you start
cleaning and maintenance works.
- Connections and repairs of the electrical equipment
may only be carried out by specialized electrical
staff.
NOTE!
After maintenance, repair and cleaning works, check
if all claddings and protective equipment are prop
-
erly reassembled to the machine and that there are
no more tools inside or in the working area of the
Machine.
Damaged protection devices and machine parts must
be properly repaired or replaced by an acknowledged
specialist workshop.