14
GS-E Series | Version 1.09
Cleaning, maintenance and repair
Retract cycles:
To ensure that the tap can successfully
retract from the workpieces after tapping, the cycle value
for retraction should be greater than that for tapping.
Value range:
0-10
8.8 User parameter for lubricating and
scrap blowing
Abb. 16: User interface
Oil Valve:
touch the button to turn on the Lubrication
switch,will spay tapping oil automatically when threa-
ding,press again to turn off the function.
Delay time:
to set oil spraying time, time between 0.1-25
seconds adjustment.
Air valve:
Press the button to turn on the Scrap Blowing
switch, blowing scrap automatically when reverse, will
stop automatically after finish.
8.9 Adjusting the coupling torque of
the collet chuck
If the collet clutch has slipped during normal tapping ope-
ration but the tap torque is not exceeded, or if it slips du-
ring tapping, the torque lock value is too small. Set the
torque of the tap clutch higher.
If the tap's torque is exceeded during normal operation of
the tap but the collet's clutch does not slip, this is an indi-
cation that the torque protection value is too large and
the clutch's torque must be set smaller.
Adjustment steps:
Remove the locking ring
Firmly hold the tapping sleeve in place
Adjust the torque with the torque spanner (see fig. 17)
Align the slot on the top with the hole in the outer rin
Insert the retaining ring end into the hole below the
slot, let it snap into place.
Fig. 17: Adjusting the coupling torque of the collet chuck
9
Cleaning, maintenance and re-
pair
9.1 Cleaning and maintenance
Tips and recommendations
To ensure that the threading machine is always in
good operating condition, regular care and main-
tenance work must be carried out.
WARNING!
Danger in case of insufficient quali-
fication of persons!
Insufficiently qualified persons cannot assess the
risks involved in repair work on the threading
machine and expose themselves and others to the
risk of serious injury.
- All maintenance work must be carried out by quali-
fied personnel only.
NOTE!
Oil, grease and cleaning agents are hazardous to the
environment and must not be disposed of in waste-
water or normal household waste. Dispose of these
agents in an environmentally friendly manner.
Cleaning rags soaked in oil, grease or cleaning
agents are highly flammable. Collect the cleaning
rags or the cleaning wool in a suitable, closed contai-
ner and dispose of them in an environmentally fri-
endly manner - not: put them in the household waste!
Wear suitable protective gloves!
Wear protective clothes!
Wear protective goggles!
Drehmoment
verringern
Drehmoment
erhöhen
Siche-
rungsring
Bohrung
Summary of Contents for 4450116
Page 22: ...www metallkraft de ...
