Owner’s Manual
19
9. MAINTENANCE
9.1 PRIOR NOTICE
Unless otherwise stated, all maintenance requires that the equipment be placed on
the ground. The use of safety stands are mandatory when servicing the equipment.
RESPECT SAFETY INSTRUCTIONS AND ALWAYS USE APPROVED TOOLS.
9.2 DAILY INSPECTION
a) Confirm all nuts and bolts are properly tightened.
b) Confirm all other fasteners are in place and are performing their specified
functions.
c) Confirm fasteners on the wings are sufficiently tightened to prevent excessive
movement from the upper wing to the abrasion shoe. However, not overly tightened,
alowing the wings to float over uneven ground.
d) Confirm all hydraulic fittings are tightened and that there are no leaks.
e) Confirm that all safety signs are in place and VISIBLE.
f) Replace any damaged parts and/or worn parts.
g) Special attention must be taken to prevent moisture from entering the male/
female connector of the wiring harness. Safety caps with molded rubber seals are
included and must be used properly when coupling and uncoupling the blade to
prevent possible failure of the wiring harness.
9.3 GREASING
Lubrication points on this equipment are identified by stickers as illustrated
(Fig. 12)
. All grease points should be greased after every 20 hours of use.
The Lubrication should be performed with a grease gun.
9.4 GREASE TYPE
Use a high-performance industrial grease for low outdoor temperature
environments.
Fig.12
MTP-0017
LUBRIFICATION POINT - POINT DE LUBRIFICATION
NEVER STAND OR STAND BETWEEN THE
EQUIPMENT AND THE GROUND IF THIS
EQUIPMENT HAS NOT BEEN PROPERLY SECURED
WITH THE SUPPORT PROVIDED FOR THIS TASK.
WARNING
