SPARK PLUG
This Go Kart comes equipped with an NGK
C7HSA spark plug.
To inspect the spark plug, remove the plug
cap (1) then remove the spark plug (2)
from the engine with the spark plug tool
provided.
Inspect the plug for carbon deposits and
clean if necessary with a wire brush. If
plug shows excessive carbon, replace the
plug.
Use a thickness feeler to inspect the spark
plug gap (2). The spark plug gap should be
0.6 - 0.7mm (0.024 - 0.028 in.)
0.6 - 0.7 mm
(0.024 - 0.028 in)
NGK C7HSA
Re-install the inspected plug or a new
plug until finger tight. Finish tightening
plug with a wrench. If spark plug is a new
plug, tighten approximately 1/2 turn more
with the wrench. If plug is an old plug,
tighten approximately 1/8 turn more with
a wrench.
2
Dirt can damage the engine if it
enters the spark plug hole.
Make sure the spark plug hole is
covered after removing plug.
CAUTION
1
MAINTENANCE
30
2
