Metal-Fach T229, Instruction Manual

Page: 48 / 64

48
INSTRUCTION MANUAL – T229, T241 FRONT LOADER
6. Scheduled Inspections
6.1 User Inspections
After each use of the Loader:
−
check all bolt connections,
−
check the condition of hydraulic lines and quick couplers,
−
ensure that the hydraulic system is not leaking,
−
remove the work tool from the Loader,
−
leave the Loader in the idle position or remove it from the frame (Chapter 2.4),
−
protect the hydraulic lines against UV rays.
The rating plate can only be replaced in the service. Illegible pictograms should be
replaced with new ones. Replace damaged grease nipples.
After each 10 hours of operation and at the end of the season, lubricate the points
shown in the figure with LT-43 Bearing Grease. Replace hydraulic hoses every 3 years.
Following the first 10 hours of operation, inspect and retighten all bolts and nuts using
correct torque. Recheck every 50 hours of operation.
Inspections and maintenance operations must be carried out with the engine switched
off and key removed from the ignition, with the auxiliary brake engaged and the boom lowered
onto the ground. The machine must be cleaned and thoroughly inspected, paying attention to
the quality of protective paint coating. If necessary, re-coat the machine with the paint repair
kit offered by the manufacturer.
Before each season, verify loader operation (without load) by activating the arm and
rotating the tool (Chapter 3).
Figure 41. Lubrication points
6.2 Service inspections
The periodical routine inspections are recommended to be performed after each two
seasons of machine use.
It is recommended to use original spare parts to ensure full capacity of the Loader for
a long period of use.