ENGLISH
13
working machine has been turned
OFF.
3
Note:
For extended daily use of your wood-
working machine an automatic power
relay for the dust extractor would be of
advantage This relay turns the dust ex-
tractor time-delayed ON and OFF once
the woodworking machine is turned ON
or OFF respectively.
This automatic power relay is available
from the manufacturer in two versions
(see chapter "Available Accessories").
A
Danger!
Prior to all servicing:
1. turn the machine OFF,
2. unplug,
3. wait until the machine has come to
a complete stop.
– Repair and maintenance work oth-
er than described in this section
should only be carried out by quali-
fied specialists.
– Replace defective parts, especially
of safety devices, with genuine re-
placement parts only. Parts not test-
ed and approved by the manufac-
turer can cause unforeseen
damage.
– Check to see that all safety devices
are operational again after each
service.
6.1
Maintenance
Before switching ON
Visual check to see if power supply ca-
ble and power cable plug are damaged;
have faulty parts replaced by a qualified
electrician.
The machine requires no maintenance.
However, before switching ON perform
the following checks.
•
Check all screw connections!
Retighten loose connections.
•
Is the switch housing, motor or fan
housing damaged? Have these
parts immediately replaced by a
qualified electrician.
•
Is the upper dust bag or suction
hose damaged? Replace the dam-
aged part(s).
6.2
Cleaning
•
Wipe work stand and fan housing
with a moist cloth.
•
Motor and ON/OFF switch may only
be cleaned with a dry cloth.
•
The upper dust bag should only be
beaten (make sure dust collection
bag is installed on the underside of
the machine).
•
Change the chip collection bag
when it is about 4/5 full.
6.3
Storage
•
For storing the dust extractor, place
the suction hose over the motor and
insert the end in the opening in the
base plate.
A
Danger!
•
Store the machine in such way that
it can not be started by unauthor-
ised persons.
•
Make sure that nobody can get hurt
by the stored machine.
A
Caution!
•
Do not store machine unprotected
outdoors or in damp environment.
6.4
Repairs
A
Danger!
Repairs to electric tools may only be
carried out by a qualified electrician!
Electric tools in need of repair can be
sent to the Service Centre in your coun-
try. Refer to the spare parts list for the
address.
Please attach a description of the fault
to the electric tool.
For special tasks the following accesso-
ries are available from specialist retail-
ers:
A
Automatic power relay
order number: 0913014626
ALV 1, single-phase 230 VAC,
for time-delayed switch-on or
switch-off of the dust extractor after
the woodworking machine has been
switched on or off.
B
Automatic power relay
order number: 0913014634
ALV 10, three-phase 400 VAC, sin-
gle-phase 230 VAC
C
Filter cartridge
order number: 0920016529
filters out ultrafine dust particles,
effective filter surface 52 m
2
D
Chip collection bag
order number: 0913017617
Power tools should not be
disposed of with household
waste. According to Europe-
an directive 2002/96/EC on
waste electrical and elec-
tronic equipment used pow-
er tools must be collected separately
and taken to an appropriate recycling
facility.
Contact your local council for the dis-
posal options for your old tool.
The tool packaging is 100% recyclable.
6.
Care and Maintenance
7.
Available Accessories
8.
Disposal
